Makita RT001GM210 Instruction Manual

Also see for RT001G: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

27 ENGLISHDescription of the wireless activation lamp status► Fig.82: 1. Wireless activation lampThe wireless activation lamp shows the status of the wireless activation function. Refer to the table below for themeaning of the lamp status.Status Wireless activation lamp DescriptionColorOn BlinkingDurationStandby Blue 2 hours The wireless activation of the vacuum cleaner is available. Thelamp will automatically turn off when no operation is performedfor 2 hours.Whenthe tool isrunning.The wireless activation of the vacuum cleaner is available and thetool is running.ToolregistrationGreen 20 seconds Ready for the tool registration. Waiting for the registration by thevacuum cleaner.2 seconds The tool registration has been finished. The wireless activationlamp will start blinking in blue.CancellingtoolregistrationRed 20 seconds Ready for the cancellation of the tool registration. Waiting for thecancellation by the vacuum cleaner.2 seconds The cancellation of the tool registration has been finished. Thewireless activation lamp will start blinking in blue.Others Red 3 seconds The power is supplied to the wireless unit and the wireless activa-tion function is starting up.Off - - The wireless activation of the vacuum cleaner is stopped.Cancelling tool registration for thevacuum cleanerPerform the following procedure when cancelling thetool registration for the vacuum cleaner.1. Install the batteries to the vacuum cleaner and thetool.2. Set the stand-by switch on the vacuum cleaner to"AUTO".► Fig.83: 1. Stand-by switch3. Press the wireless activation button on the vac-uum cleaner for 6 seconds. The wireless activationlamp blinks in green and then become red. After that,press the wireless activation button on the tool in thesame way.► Fig.84: 1. Wireless activation button 2. Wirelessactivation lampIf the cancellation is performed successfully, the wire-less activation lamps will light up in red for 2 secondsand start blinking in blue.NOTE: The wireless activation lamps finish blinking inred after 20 seconds elapsed. Press the wireless acti-vation button on the tool while the wireless activationlamp on the cleaner is blinking. If the wireless acti-vation lamp does not blink in red, push the wirelessactivation button briefly and hold it down again.