Makita SC103D Instruction Manual

Also see for SC103D: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

8 ENGLISHNOTE: Use a dry cloth to wipe the dirt off the lens ofthe lamp. Be careful not to scratch the lens of lamp, orit may lower the illumination.NOTE: When the tool is overheated, the lamp willblink. Let the tool cool down in this case.Guide scaleUse the guide scale if you wish to cut threaded rods inthe same length. Insert the guide scale into the hole asshown in the figure.12► 1. Guide scale 2. Clamping screwAlign the value of your desired length on the guide scalewith the cutting line. Then tighten the clamping screw.213► 1. Guide scale 2. Cutting line 3. Clamping screwCAUTION: Do not hold the guide scale tocarry or handle the tool. The tool may fall off andcause personal injury and/or damage to the tool.Rod guideFor a precise cutting, set the rod guide in positiondepending on the diameter of the threaded rod to be cut.1 2► 1. Rod guide (Position 1) 2. Rod guide (Position 2)There are two rod guide positions.Position Size of threaded rod1 W3/8, 3/8-16UNC, M102 W5/16, W1/4, 5/16-18UNC, 1/4-20UNC,M8, M6HookCAUTION: Never hook the tool on a windylocation or a potentially unstable surface.CAUTION: Do not use the hook when it isdeformed or damaged.CAUTION: When not operating the tool,always fold the hook.The hook is convenient for hanging the tool temporarily.1► 1. HookCAUTION: Do not hang the hook from thewaist belt. It may result in personal injuries and/ordamage to the tool if dropped.