Makita TD111DZ Instruction Manual

Also see for TD111D: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

7 ENGLISHIndicating the remaining batterycapacityOnly for battery cartridges with the indicator► Fig.2: 1. Indicator lamps 2. Check buttonPress the check button on the battery cartridge to indi-cate the remaining battery capacity. The indicator lampslight up for a few seconds.Indicator lamps RemainingcapacityLighted Off75% to 100%50% to 75%25% to 50%0% to 25%NOTE: Depending on the conditions of use and theambient temperature, the indication may differ slightlyfrom the actual capacity.Switch action► Fig.3: 1. Switch triggerCAUTION: Before installing the battery car-tridge into the tool, always check to see that theswitch trigger actuates properly and returns tothe "OFF" position when released.To start the tool, simply pull the switch trigger. Toolspeed is increased by increasing pressure on the switchtrigger. Release the switch trigger to stop.NOTE: The tool automatically stops if you keep pull-ing the switch trigger for about 6 minutes.Lighting up the front lampCAUTION: Do not look in the light or see thesource of light directly.► Fig.4: 1. Lamp► Fig.5: 1. ButtonPull the switch trigger to turn on the lamp. To turn off,release it. The lamp goes out approximately 10 secondsafter releasing the switch trigger.To keep the lamp off, turn off the lamp status. First pulland release the switch trigger. And then press the but-ton for one second within 10 seconds.To turn on the lamp status again, press the button againsimilarly.NOTE: To confirm the lamp status, pull the trigger.When the lamp lights up by pulling the switch trigger,the lamp status is ON. When the lamp does not comeon, the lamp status is OFF.NOTE: When the tool is overheated, the light flashesfor one minute, and then the LED display goes off. Inthis case, cool down the tool before operating again.NOTE: Use a dry cloth to wipe the dirt off the lens ofthe lamp. Be careful not to scratch the lens of lamp, orit may lower the illumination.Reversing switch action► Fig.6: 1. Reversing switch leverCAUTION: Always check the direction ofrotation before operation.CAUTION: Use the reversing switch only afterthe tool comes to a complete stop. Changing thedirection of rotation before the tool stops may dam-age the tool.CAUTION: When not operating the tool,always set the reversing switch lever to the neu-tral position.This tool has a reversing switch to change the directionof rotation. Depress the reversing switch lever from theA side for clockwise rotation or from the B side for coun-terclockwise rotation.When the reversing switch lever is in the neutral posi-tion, the switch trigger cannot be pulled.