Makita WST01N Instruction Manual

43. Grab the handle with both hands and pull it backwardsthrough your weight.4. Raise the handle up to your desired one of heightlevels 1 to 5 according to your work by aligning theindex bar with the height positions shown on the label.5. Turn the adjusting bolt so that the miter saw stand canbe stable.Folding: (Fig. 4)1. Place your foot on the pipe of the leg A of miter sawstand.2. Grab the handle with both hands and pull it backwardsthrough your weight.3. Hold the handle firmly and pull the shift lever with afinger while holding it.4. Lower the handle up to your desired one of heightlevels 1 to 5 according to your work by aligning theindex bar with the height positions shown on the label.5. Lowering further after going past the height level 1lock the handle by itself.6. The miter saw stand can be moved with wheels asshown in the figure.Setting up the extension arms (for the repetitivelength stopper and the roller): (Fig. 5 & 6)1. Move the lever 40 toward the side of miter sawplacement in the A direction of arrow, pull out theextension arm until its end reaches the repetitivelength or the support length and lock it by moving thelever 40 in the B direction of arrow.2. Pull out the pin 10-60, pivot the leg so that it is upright.Make sure that the pin top end is locked in the hole inthe leg pipe.3. Loosen the clamping screw M8 x 20 on the legcounterclockwise, pull out the leg pipe until it reachesthe floor and tighten the clamping screw M8 x 20 backcounterclockwise the leg pipe.4. Loosen the clamping screw M8 x 20 on the side of thestopper for the repetitive length or the rollercounterclockwise, raise or lower the stopper (or theroller) until the top edge of the stopper (or the top ofroller) reaches the same level as the top surface of themiter saw table. Retighten the clamping screw M8 x20 clockwise to lock the stopper (or roller).Storing the extension arm for both the stopper to gainrepetitive cuts and the roller: (Fig. 5 & 6)1. Loosen the lever 40, push back the leg pipe 28 andretighten the lever.2. Loosen the lever 40 nearer to the stopper (or theroller), press down the stopper (or the roller) andretighten the lever.3. Pull out the pin 10-60, pivot the leg until it reaches tothe horizontal position.4. Loosen the lever 40, push back the extension arm asfar as it will go and retighten the lever firmly to lock theextension bar.