Makita XSJ05T Instruction Manual

Also see for XSJ05: Instruction manual

7 ENGLISHASSEMBLYCAUTION: Always be sure that the tool isswitched off and the battery cartridge is removedbefore carrying out any work on the tool.Removing and installing shearbladesCAUTION: Never remove the blades with barehands. Wear gloves.The sharp edge of the blade may cause injury.Removing cutting headUse the hex wrench (5/32") to loosen the bolts whichsecure the cutting head. Pull the cutting head straightout by turning it left and right alternately.123 4► 1. Cutting head 2. Bolt 3. Hex wrench (5/32")4. LoosenRemoving shear bladesNOTICE: Hold the blades and the sleeve not to fallfrom the cutting head.NOTICE: Be careful not to lose the sleeve.Remove the bolts which hold the blades. Then theblades can be removed easily.12345► 1. Bolt 2. Side blade L 3. Center blade 4. Side bladeR 5. SleeveInstalling shear bladesInsert the center blade, the side blade L, the side bladeR, and the sleeve into the cutting head.Tighten the bolts. In this process, the bolt heads shouldbe protruding 2 - 3 mm from the cutting head surface.If you tighten the bolts excessively, the cutting headcannot be installed to the tool.7215346► 1. Cutting head 2. Side blade R 3. Center blade4. Sleeve 5. Sleeve 6. Side blade L 7. BoltInstalling cutting headCAUTION: Secure the cutting head firmly.Otherwise the cutting head may rotate during opera-tion and cause serious injury.Insert the cutting head into the tool by turning it left andright alternately. Then tighten the three bolts with thehex wrench (5/32").1234► 1. Cutting head 2. Bolt 3. Hex wrench (5/32")4. Tighten