Malibu Boats 2000 Owner's Manual

4-22) Wax the boat hull and deck after every three or four outings to decrease waterfriction and to lessen the potential for staining or spotting the gelcoat surface. Incases where the original gelcoat shine cannot be restored by waxing, hand buffthe surface using any commercial compound. Be sure to apply several coats ofwax over the area that has been polished.Surface StainsStains can appear as a result of dust, road tar, plant sap, rust from metal fittings, and othermaterials coming in contact with your boat’s exterior. Listed below is a step-by-stepprocedure to remove stains from your boat:1) Wash area with dish washing soap2) Apply a mild cleanser on a small area (3 x 3 feet)3) Rinse with fresh water4) Buff with a fine rubbing compound5) WaxIf the stain is not removed by the dish washing soap or mild cleanser, then the nextprocedure is to use either denatured or rubbing alcohol. Common rubbing alcohol isexcellent for removing stains.ScratchesScratches to the gelcoat sometimes occur during normal use. Your dealer can usuallyrestore the gelcoat to like-new condition.Underwater CorrosionCorrosion occurs in saltwater conditions from the interaction of the saltwater and thedirect current of the battery. To prevent corrosion, it is important to keep the bilge area asdry and clean as possible.Care For Boats That Are MooredDue to gelcoat discoloration, osmosis (blistering), and algae growth, it is notrecommended that you leave your boat moored for long periods of time. If your boat willbe moored in fresh water or saltwater for extended periods of time, you should do thefollowing:1) Haul-out and clean your boat regularly (every 14 to 21 days). Use soap, water,and plenty of elbow grease.2) Apply wax after cleaning.You should also check with your local Malibu dealer about anti-fouling paint and otherproducts that can be applied to the hull bottom below the water line.TeakCare must be taken to keep teak wood from turning gray or rough. The roughing becomesmore apparent as the moisture evaporates and dries out.It is suggested that you use teak or mineral oil treatments at least four times a year tomaintain the appearance of your swim platform. Use a high quality teak oil which can bepurchased at your local Malibu dealership.Notice: Teak wood should never be varnished.