NAD T 535 Owner's Manual

Also see for T535: Catalog Owner's manual Specifications

NAD T 535 Owner's Manual Manual pdf 8 page image

IDENTIFICATION OF CONTROLSREAR PANEL1 MIXED AUDIO OUT: Connect to the corresponding analog audioinput of an amplifier, receiver or stereo system.2 5.1CH AUDIO OUT: The T 535 contains a multi-channel decoder. Itenables playback of discs recorded in multi-channel surround withoutthe need for an optional decoder.Connect to the corresponding multi-channel audio input of a receiveror a processor.3 DIGITAL OUT (COAXIAL, OPTICAL): Connect the optical or coaxialdigital OUT ports to the corresponding S/PDIF digital input of arecording component such as a CD recorder, DAT deck, computersoundcard or other digital processors.4 IR IN: This input is connected to the output of an IR (infrared) repeater(Xantech or similar) or the IR output of another component to allowcontrol of the T 535 from a remote location. Most NAD products with IROUT are fully compatible with the T 535.5. RS-232: Connect this interface via RS-232 serial cable (not supplied)to any Windows® compatible PC to allow remote control of the T 535through NAD’s proprietary PC software or other compatible externalcontrollers.Please log on to www.nadelectronics.com/software for the latest PCinterface control software.NAD is a certified partner of AMX and Crestron and fully supports theseexternal devices. See your NAD audio specialist for more information.6. SCART/RGB OUT (Euro model/PAL only): Connect the T 535’s[SCART/RGB OUT] to the SCART/RGB video input of a compatible videomonitor/TV. Be sure to observe the correct orientation of the SCART/RGB plug.7 HDMI OUT: Using a HDMI cable (not supplied), connect the HDMI OUTjack to the corresponding HDMI input jack of an HDTV, a projector or anA/V Receiver.NOTES• Toggle the HDMI button of DVD 9 remote control to turn ON or OFFHDMI output. When turned ON, “HDMI ON” will be displayed in the VFDfollowed by the applicable resolution setting.• There will be no component video output at “HDMI ON”.• HDMI button in the DVD 9 remote control will not elicit any response ifthe HDMI cable is either unplugged from the HDMI OUT terminal or notconnected to a HDMI-capable TV/monitor.WARNINGBefore connecting and disconnecting any HDMI cables, both the T 535and the ancillary source must be powered OFF and unplugged from theAC outlet. Failure to observe this practice may cause permanent damageto all equipment connected via HDMI sockets.8 VIDEO OUT/S-VIDEO OUT: Connect to video input of the monitor/television using quality dual-RCA and/or S-Video cables designed forvideo signals. In general, the S-Video connection is superior and shouldbe used if your TV/monitor provides the corresponding input.9 COMPONENT VIDEO OUT: Connect the T 535’s COMPONENT VIDEOOUT to the component video input of a compatible video monitor/TVor an A/V Receiver with applicable component video input. Be sure toobserve consistency in connecting the appropriate Y, Cb/Pb, Cr/Pr jacksto the corresponding sources/inputs. Do not rely purely on the colorcoding of the jacks, which may not always be consistent among brands.The T 535’s component-video output is a fully wide-band output,compatible with all HDTV formats. On-screen display menu is alsoshown at component video output.10 AC POWER INLET: Connect to the supplied IEC-standard removableAC power cord or a compatible cord.3 4 5 6 7 8 91 2 10ATTENTION!Please make sure that the T 535 is powered off or unplugged before making any connections. It is also advisable to power-down or unplug all associatedcomponents while making or breaking any signal or AC power connections.8ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ