NAD T 758 Owner's Manual

Also see for T 758: Owner's manual Quick setup guide Installation guide Quick setup guide

NAD T 758 Owner's Manual Manual pdf 7 page image

6 VACUUM FLUORESCENT DISPLAY (VFD)• Displays visual information about the current settings like theactive Source, volume level, listening mode, audio format and otherrelated indicators.• Refer also to the item about DISPLAY SETUP under the USING THET 758 - SETUP MENU segment of the OPERATION section.7 REMOTE SENSOR• Point the AVR 4 remote control at the remote sensor and press thebuttons.• Do not expose the remote sensor of the T 758 to a strong lightsource such as direct sunlight or illumination. If you do so, you maynot be able to operate the T 758 with the remote control.Distance: About 23ft (7m) from the front of the remote sensor.Angle: About 30° in each direction of the front of the remote sensor.8 a SOURCE s• Toggle through the input selections - Source 1, Source 2, Source 3,Source 7, Front Input and Media Player. More Sources can be directlyrecalled upon enabling them at the Setup Menu.• Refer also to the item about SOURCE SETUP under the USING THET 758 - SETUP MENU segment of the OPERATION section.9 VOLUME• The VOLUME control adjusts the overall loudness of the signal beingfed to the loudspeakers or headphones.• Turn clockwise to increase the volume level; counter clockwise tolower it.10 PHONES• Accepts stereo headphone using a standard 1/4-inch stereo phoneplug (use a suitable adaptor for headphones equipped with asmaller plug).• Plugging in headphones automatically mutes output from thespeakers.• For headphone listening, the Front speakers must be set to “Large” atthe “Speaker Configuration” of the Speaker Setup item at the SetupMenu; otherwise headphone bass response will be restricted.• Plugging in headphones will automatically switch the T 758 toStereo, Stereo Downmix or Analog Bypass modes.11 FRONT INPUT PORTS• Use these convenience jacks for occasional sources such as acamcorder, video game console, any analog audio or optical digitalaudio sources and composite video sources.• If your source has two output jacks indicative of stereo output,insert both jacks into the T 758’s corresponding Front “L” (item A) and“R (MONO)” input to achieve stereo output as well.• On the other hand, if your source has a single audio out jack only oris marked “Mono output”, plug this into the T 758’s Front “R (MONO)”input (item B).• Connect composite video output source to the front compositevideo input (item C).• Use the front optical audio input (item D) for optical digital audiosources.12 FRONT MP/MIC INPUT• Connect your Media Player’s standard stereo phone jack to thisinput.IDENTIFICATION OF CONTROLSFRONT PANEL7ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ