NAIM SUPERUNITI - Manual

Also see for SUPERUNITI -: Connection guide Guide Supplement Reference manual Quick start guide Quick start guide

NAIM SUPERUNITI - Manual Manual pdf 4 page image

2SuperUniti Installation and Connection2.2 Mains Power ConnectionConnect the SuperUniti to a mains power socket usingeither the mains cable supplied or a Naim Power-Line.2.3 FM/DAB Aerial ConnectionThe SuperUniti FM/DAB module will only be able to providehigh quality FM and DAB radio if a strong, interference-free radio signal is available. The SuperUniti rear panel FM/DAB Aerial socket must be connected, via 75 Ohm low-loss coaxial cable, to a suitable aerial. The aerial shouldbe mounted clear of large obstructions and as high aspossible; ideally on a roof.Note: Your local retailer should be able to offer advice ona suitable aerial and aerial installer.2.4 Audio Inputs and Outputs2.4.1 Audio Signal InputsSuperUniti provides four stereo analogue inputs and sixS/PDIF digital inputs including one combined analogue/digital input socket. Connection to the inputs is made viaa variety of socket types. The following table lists the inputsand their socket type:Input Type Socketan. 1 Analogue 5-pin DINan. 2 Analogue RCA phonosan. 3 Analogue RCA phonosfront panel Analogue 3.5mm jackDigital 3.5mm mini-TosLink jackdig. 1 Digital Coaxial (BNC)dig. 2 Digital Coaxial (RCA phono)dig. 3 Digital Optical (TosLink)dig. 4 Digital Optical (TosLink)dig. 5 Digital Optical (TosLink)Note: The front panel analogue/digital jack socket canaccept both conventional analogue 3.5mm plugs andmini-TosLink optical digital plugs. It will automaticallyidentify the type of plug inserted and handle the signalappropriately.Always use high quality interconnect cables to connectsources to SuperUniti inputs.2 SuperUniti Installation and ConnectionYour SuperUniti should be installed on an equipment stand intended for the purpose.Ensure it is well ventilated, and do not stand it directly on top of another item ofequipment. It should be installed in its final location before connecting cables or switchingon. The SuperUniti has no standby mode and is intended to be left switched on.Connecting the SuperUniti to mains power and to a variety of audio peripherals andsources is described in the following paragraphs. Diagram 2.1 illustrates the SuperUniti rearpanel connection sockets.2.1 SuperUniti Rear Panelmains inputand fusepower switch network socketDAB/FM aerialsocketleftspeaker rightspeakersignal ground switchpreamp output subwooferoutput analogueinputsdigitalinputsremotein/outupgrade interfacemini-USB digital outputwireless network(Wi-Fi) antenna socket