Battery Restore report.(3) Trouble Restore - Program to activate aTrouble Restore report.(4) Fire Restore - Program to activate a FireRestore report.[39]Opening/Closing Report, Telco 1Select users required to send opening andclosing reports to Telephone Number 1.Do not program for users that are intendedto send an Opening After Alarm (CancelCode) or Conditional Closing reports.Backup Telephone Programming[40]Subscriber ID Number (Telco 2)For 4/2 format enter a 4 digit number. If 3/1format is required enter a 3 digit numberthen press the i key.[41]Telephone Number 2Program the phone number to be dialed forTelephone Number 2. A fixed dial tonedetection (E) is included prior to the DialingPrefix [44]. Dial tone detection can bedisabled by programming No Dial ToneDetection [46-1]. To program any additionaldelay enter a "D" where required in thephone number.[42]Receiver Format (Telco 2)Select the format that will be used to reportfor Telco 2 (Backup reporting). Refer tosection [32].[43]Receiver Options (Telco 2)Refer to section [33] Receiver Options.[44]Dialing PrefixDialing prefix for Telco 1, Telco 2, and Telco3. Program if using an Outside accessnumber.[45]Communicator Features 1(1) Communicator Enabled - Program toenable the communicator.(2) DTMF with Rotary Backup - The firstattempt to communicate is dialed using theTouchTone method of dialing, subsequentattempts are dialed using the pulse methodof dialing. Disable this feature to dial usingonly rotary dialing.(3) DTMF only - All attempts tocommunicate dial using the TouchTonemethod of dialing.(4) Backup Reporting to Telco 2 - After 2attempts are made to communicate to Telco 1the backup phone number is dialed (Telco 2).[46]Communicator Features 2(1) No Dial Tone Detection - Program todisable dial tone detection for Telco 1, Telco2 and Telco 3.(2) 2:1 Rotary Dialing - Changes the makebreak ratio when rotary dialing from 1.5:1 to2:1.(3) Backup if < 4 attemps - If BackupReporting [45-4] has been enabled, thecommunicator will use Telephone Number 2[41] for the remaining retries when there areless than 4 retries remaining.(4) ReservedPager ProgrammingIf Pager Format ([32]and/or[42]and/or[52] =7) is selected, pager data will be displayedas shown in Figure 8. If Pager Format isselected 4/2 format must be programmedand Sumcheck is not permitted. If a PINnumber is required refer to Leading Digits[47].Pager Alarm data is the same as 4/2 formatwith the exception that the 2 digit ReportCode is transmitted before the 4 digitSubscriber ID.000 033-1234Leading DigitsReport CodeSubscriber ID NumberFIGURE 8 D EFAULT P AGER D ISPLAY