NAPCO RPXP6GT Installation Instructions Manual

Also see for EXPRESS XP-600: User manual Datasheet User guide User guide User guide

NAPCO RPXP6GT Installation Instructions Manual Manual pdf 9 page image

Delay Tone. Enter a valid Arm/Disarm code. Ifa valid Arm/Disarm code is entered, the keypadwill beep 6 times, indicating the panel has beendisarmed. The red Armed LED will go out. If anincorrect Arm/Disarm Code is entered, thekeypad will sound a 1-second tone, indicatingincorrect entry. Press the B key and re-enterthe code.Disarming after an Alarm (Alarm Memory)The armed LED and the zone(s) that caused thealarm will be be flashing. Disarm the panel.The system is currently not detecting zone faultsor displaying system trouble. The zone(s) thatcaused the alarm will continue to flash. TheReady and H SYSTEM TRBL LEDs are outindicating:The system is displaying Alarm Memory.Press the B key to clear Alarm Memory.BypassingAutomatic BypassingHome/Away with Delay ZonesThis zone type has the following operationdepending on whether an Exit/Entry Zone hasbeen violated during the Exit Delay time.HomeExit/Entry Zone is not violatedZones selected as Home/Away with DelayZones will be bypassed automatically.Away with DelayExit/Entry Zone is violatedZones selected as Home/Away with DelayZones will have a fixed 20-second entrydelay when violated before an Exit/EntryZone.Full Setting the System with AutomaticBypassing - Home/Away with DelayZonesFrom the KeypadPress C B to return protection toHome/Away with Delay Zones that havebeen automatically bypassed. Threeminutes are allowed to walk through Exit/Entry and Exit/Entry Follower Zones.Using A Keyfob (GEM-KF)All zones in the system can be armedregardless of the state of the Exit/EntryZone when arming with a Keyfob and usingan AUX key programmed as Full Set.Press K and press and hold the M orN keys for 1.5s when leaving thepremises. All zones, including Home/AwayZones are armed.Bypassing a zonePress the C key, then the zone number to bebypassed. While the panel is DISARMED, thebypassed zone LED will flash slowly; indicatingthe zone has been bypassed. While the panel isW ARMED, the bypassed zones will only bedisplayed if the Display Bypassed [21-3] optionhas been selected.Unbypassing a zone (Disarmed only)Press the C key then the number of thezone to be unbypassed.Group BypassPress C C to Bypass all Exit/EntryFollower Zones [02] or Home/Away Zones[01] (only if the system is programmedexclusively for Home/Away with Delayzones)..Using A Keyfob (GEM-KF)Hold the M or N key on the Keyfob toBypass all Exit/Entry Follower Zones [02] orHome/Away Zones [01] (only if the system isprogrammed exclusively for Home/Awaywith Delay zones).User Program ModeTo prevent the loss of the User 1 Code, thepanel default program includes User 1 CodeLockout [96-2].