2-32.1.2 GT01 and GT11 Installation MethodSecure the GT to the installation panel using the four fittings and four screws provided with the unit.1. Place the GT main unit in the installation panel.2. Insert the fittings into the grooves provided in the GT main unit, and tighten the screws tosecure the GT main unit to the installation panel.Note:Screw tightening torqueThe screw tightening torque should be 0.1 N m to 0.25 N m. Tightening screws too hard may be a causeto deform the case and other parts, and may cause to deteriorate the waterproof property or damages inthe functions.Applicable panel thicknessA panel with a thickness of 1.0 to 5.0 mm should be used.Clearance when the GT is installedWhen installing the GT, if other parts are being installed to the panel or cables are being wired to it, werecommend providing a clearance of 30 to 50 mm around the GT. This prevents cables from beingdamaged, and facilitates the installation work. Also, make sure that the slits in the main unit are neverobstructed.When using the GT11 connecting our Programmer II or C-NET adapter to the TOOL portUsable ambient temperature is 45 °C.
