NCR 7882 Installation And Owner's Manual

NCR 7882 Installation And Owner's Manual Manual pdf 22 page image

7882 Scanner Installation and Owner Guide04/01 497-0419630 Release D22 of 58Checkstand Cutout1. Put the NCR 7882 into the hole in the checkstand. Diagrams in NCR 7882Specifications show the various dimensions of the hole.2. Align the 7882 to the Checkstand. The leading edge of the Top Plate must be flushor up to 1/16 in. (0.15 cm) below the top of the checkstand. The trailing edge of theTop Plate must be flush or up to 1/16 in. (0.15 cm) above the top of the checkstand.Correct AlignmentHigh SurfaceLow SurfaceHigh SurfaceLow Surface14231Scanner Too LowBad AlignmentBad AlignmentScanner Too HighCheckpoint CableIf you are installing and NCR 7882 Scanner, with the Checkpoint feature, on a VerticalMounting Bracket, route the Checkpoint Cable along side the Interface Cable.Note – If the installation includes the Checkpoint feature, a representative fromCheckpoint must connect the Checkpoint Cable to the Checkpoint equipment after youinstall the NCR 7882.Cable ClampsThe NCR 7882 is supplied with two Cable Clamps (006-0687102). Install these clampsunder the checkstand as needed to support the cables and keep them out of theoperator’s way.