NDC InstantWave NWH660 User Manual
                                                     | |
Contents
| 
InstantWave High Speed Access Point 9Getting StartedAccess Point Hardware InstallationAccess Point Hardware Setup explains how to quickly setup the Access Point foruse via a wired Ethernet connection, and using the factory default settings. Forinstallation in networks using other than the default settings, i.e. into existingnetworks, complete the Hardware Setup and refer to AP COMFig Tool, page 13.To setup a wireless station, refer to the PCI/PC Card UserFigure 4. Access PointStep1 . Screw the antenna into the back of the AP (see Figure 5). Placing theantenna in a higher location may result in better signaltransmission/reception to/from the wireless stations (see Placing ForPerformance, page 8)Figure 5. Access PointStep2 . Connect the Ethernet network cable to either the UTP port (see Figure5). If both types of cables are connected at the same time, the AP willonly utilize the UTP connection firstStep3 . Connect the power adapter to the electricity outlet and then to theAccess Point DC-In port (see Figure 5 )Step4 . Turn on the AP power switchRear |
Related manuals for NDC InstantWave NWH610
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine