105ADUSTING HEADSET RINGERTONE VOLUMEYou can adjust the ringer tone volume for the headsetin idle/busy status.To Adjust the Ringer Tone Volume in IdleStatusSTEP 1: Press the Headset key while in idle status toswitch from headset mode to handset mode,and the Headset key lamp turns off.STEP 2: Receives a call from another line.STEP 3: Press Up/Down ( ) key while a ringer toneis on.For Ringer Tone Volume in Busy StatusIf other lines are accommodated in the telephone as asubline, the ring tone volume is lower than normalwhen other lines receive calls during a call with theheadset on.HOW TO USE THE WIRELESSHEADSETWhen using Wireless Headset, you can answer a call,conduct a conversation, or disconnectthe call with hooking operations. This section explainsabout the terminal operation using Wireless Headset.To Answer a CallSTEP 1: Press Hook key of the Wireless Headsetwhile the ringing tone is on, and the Hook keylights red. Depending on the installationphase, you can answer the call by pressingkey instead of Hook key.STEP 2: Press Hook key to end the call, and the Hookkey turns off.Note: To provide a ringer tone from the headset, thesystem configuration is required. For details, con-tact the system administrator.Note: Ringer tone volume can be adjusted only for thewired headset which is connected to the terminalheadset connector.Note: Ringer tone volume in busy status cannot bechanged when the ringer tone is set to come fromboth the speaker and the headset. For details,contact the system administrator.Note: When you receive an incoming call from otherline while in a conversation with headset, theringer tone volume for other lines in headsetmode can be set the same as the normal volume.For details, contact the system administrator.DT830 DT430/410Note: The Hook key of Wireless Headset must be pro-grammed in advance. For the programming ofHeadset key, contact the system administrator.Note: For details on how to connect a telephone andWireless Headset, see the manual attachedto the Wireless Headset.DT830 DT430/410Answer
