247• Manual ConnectionSTEP 1: Be sure to confirm that Bluetoothconnection is ON (The Connect keylights red).STEP 2: Press the Connect key less than 3seconds.STEP 3: The terminal sends a connection requestto the most recently connected mobilephone.STEP 4: Bluetooth connection between theterminal and the mobile phone will beestablished.• To switch the call by using BluetoothfeatureWhen you leave the desk while talking in Mo-bile Phone Mode, you can switch from the callwith terminal handset to the call with mobilephone. For the details of Mobile Phone Mode,see TERMINAL MODE.STEP 1: Press the Connect key less than 2.5seconds. This operation is canceled bypressing the Connect key again.STEP 2: The call switches from the terminal to themobile phone. To switch the call usingmobile phone, refer to the manual of yourmobile phone.TERMINAL MODEFor DT830 Series/DT430 Series, there are two types ofterminal mode called “Wired Telephone” mode and“Mobile Phone” mode. The terminal starts up on “WiredTelephone” mode by default.• Wired Telephone ModeEnables the terminal to make a voice call as a station in thesystem.• Mobile Phone ModeEnables the terminal to make a voice call for mobile phone.• To switch the terminal modeWhen the Bluetooth connection betweenDT830 Series/DT430 Series and a mobilephone is completed, you can switch the termi-nal mode (“Wired Telephone” mode/“MobilePhone” mode) by pressing the Path key.The Path key indicates the mode status withthe lamp color and the flashing status. Whenthe Path key lights or flashes orange, the ter-Note: When the terminal is placed in Security mode, theBluetooth feature will be OFF even if the terminalis in busy/idle state. After that, the terminal modeswitches to the Wired Telephone Mode.Note: When the Security mode is canceled, theBluetooth feature will be ON. However, theterminal mode will be the Wired Telephone Mode.
