Configuring Your System 3-21Clearing and Changing the PasswordsTo clear and change the passwords:1. Power off the system and remove the left side panel as described inChapter 4 of this guide.2. Check to ensure the system power cord is removed from the back of thesystem.3. Remove the spare jumper from position 11 - 12 on jumper block.4. Reinstall the spare jumper on position 3 - 4 (Password Disable) of thejumper block. Refer to Figure 3-1 and Table 3-3 to find the location of thisjumper.5. Connect the power cord, power on the system and while waiting for POSTto complete, press the F2 key to enter BIOS setup. This automatically clearsall passwords, provided you exit and save the BIOS setup.6. Power off the system and remove the power cord.7. Remove the Password Disable jumper from pins 3-4 and store it in position11 - 12.8. Replace the left side panel, connect the power cord and power on thesystem.9. To specify a new password run the BIOS Setup Utility as described earlierin this chapter.
