NEC Express5800/320Fc-LR/MR Setup Manual

Contents

NEC Express5800/320Fc-LR/MR Setup Manual Manual pdf 128 page image

6-18 TroubleshootingProblems with System Repair“Press F6 if you need to install a third party SCSI or RAID driver…” was not displayed andthere was no chance to enter F5 and F6 when “When starting Recovery Console from WindowsServer 2003 CD-ROM” was performed. Did you press any key when the message “Press any key to boot from CD” is displayed ontop of the screen? Start-up from Windows Server 2003 CD-ROM is required to start the Recovery Consolefrom Windows Server 2003 CD-ROM. Press any key while the message “Press any keyto boot from CD” is displayed on the screen. You cannot start the Recovery Console fromthe CD-ROM unless the any key is pressed while the message is being displayed. Restartthe system when it does not start from CD-ROM and the message “Press F6 if you needto install a third party SCSI or RAID driver…” is not displayed. See “Starting upRecovery Console” in “SYSTEM REPAIR” in this chapter to start again.The screen turns out to be black for a while when booting the Recovery Console. If you start the Recovery Console that is installed in the system, the screen turns out to beblack for a while when booting the Recovery Console. Since the system is normallyworking, please wait for a while.When the system’s update is being processed, Operating System Stop Error occurred at thesystem reboot. During the system update process, the message “Windows-FT Orphaning A disk that ispart of a fault–tolerant volume can no longer be accessed” is displayed, and there issometimes a case that OS Stop Error occurs on a reboot after this process. SeeIMPORTANTof step 5 in “Updating the System” in this chapter when OS Stop Erroroccurs, and reboot the system. In addition, the system’s update is successfully beingperformed when the message “Windows-FT Orphaning A disk that is part of a fault-tolerant volume can no longer be accessed” is displayed. However, the mirroring of HDDis not applied. Make sure to check the hard disk’s mirroring after the system start-up.