NEC Express5800/320Ma Software Installation And Configuration Manual

Also see for Express5800/320Ma: Read me first Read me first Release notes User guide Administrator's guide

Contents

NEC Express5800/320Ma Software Installation And Configuration Manual Manual pdf 77 page image

Configuring the UPSConnecting a UPS to an Express5800/320Ma System A-3Configuring the UPS1. Turn on power to the Express5800/320Ma system, and log on to the WindowsAdministrator account.2. Verify that the UPS and its management card have been assigned an IP address,and that an Ethernet cable is connected to the UPS and to your LAN. For moreinformation, see the Network Management Card Installation and Quick StartManual from APC.3. In a Web browser, enter http:// and the IP address of the UPS (for example,http://xxx.xxx.xxx).If Internet Explorer is configured with its default security settings, a message boxwith the following message is displayed the first time you attempt to configure yourUPS with PowerChute software:Content from the Web site listed below is being blocked bythe Internet Explorer Enhanced Security Configuration.http://xxx.xxx.xxx.xxx...If you trust this Web site, you can lower security settingsfor the site by adding it to the Trusted sites zone....In this message, xxx.xxx.xxx.xxx is the IP address of either the PCNS userinterface Web page or the UPS management card Web page. Click Accept to addthis address to Trusted Sites. Make sure that Active scripting for Trusted Sites isset to either Enable (the default) or Prompt. If Active scripting is set to Prompt,allow scripting when prompted. If you close the message box without adding the IPaddress to Trusted Sites, you will be unable to configure the UPS.4. If prompted for a password, supply a valid password for the UPS.5. In the left column of the Network Management Card page, click the name of theUPS.6. In the left column, click Configuration.7. On the Configuration page, use the settings in Table A-1 for the shutdownparameters. Click Apply after you modify the settings.