12. Offline ToolsExpress5800/R320c-E4, R320c-M4 Maintenance Guide (VMware) 87Chapter 1 Maintenance12.2 Functions of Offline ToolsOffline Tools offers the following functions.Note When you start the offline tools while RDX is connected to the server, disable RDXbefore starting the offline tools by setting RDX to hibernate mode.Off-line Maintenance UtilityOff-line Maintenance Utility is started when Maintenance Utility is selected. Off-line Maintenance Utility isused for preventive maintenance and failure analysis for this product. When you are unable to start NECESMPRO due to a failure, Off-line Maintenance Utility can be used to check the cause of the failure.After starting up the Off-line Maintenance Utility, the following features are available to run.– IPMI Information ViewerDisplays System Event Log (SEL), Sensor Data Record (SDR), and Field Replaceable Unit (FRU)in IPMI (Intelligent Platform Management Interface) and also back up such information.Using this feature, system errors and events can be investigated to locate the parts to be replaced.You can also clear the SEL area, and specify the operation when the SEL area becomes full.Tips DIMM information (DIMMx FRU#y) displayed when you select Display MostRecent IPMI Data → Field Replaceable Unit (FRU) List is the one for CPU/IOmodule on primary side.For the CPU/IO module on opposite side, the following message will be displayed,however, it is not a failure.WARNING!No Information.The Device is not detected or it is broken.– System Information ViewerDisplays information on processor (CPU), BIOS.Also output the information to a text file.– System Information ManagementSet the information specific to your server (Product information, Chassis information).BMC Configuration– It is used for setups of alert functions by BMC (Baseboard Management Controller) and remotecontrol functions by Management PC.Refer to Chapter 3 (2. BMC Configuration) for more information.
