1. Installing Internal Optional DevicesExpress5800/T110i User’s Guide 75Chapter 2 Preparations1.12 Optical Disk DriveProcedures for replacing the standard optical disk drive with the optional internal DVD SuperMULTI drive aredescribed below.Important Do not install a drive manufactured by a third party.Replacing drives1.12.1Follow the procedure below to replace your drive with the optional internal DVD SuperMULTI drive.1. See Chapter 2 (1.2 Overview of Installation and Removal) for preparations.2. To remove the side cover and front bezel, see Chapter 2 (1.3 Removing the Side Cover and 1.4Removing the Front Bezel).3. Remove the duct. If a device is installed in the 5.25-inch expansion bay 1, remove it so that you canaccess the cable connected to the optical disk drive.4. Disconnect the SATA cable and DC power cablefrom the optical disk drive.5. Push the stopper on the right side and remove theoptical disk drive.6. Remove the bracket from the optical disk drive.7. Mount the bracket for the optical disk drive on the DVD SuperMULTI drive.8. Install the bracket with DVD SuperMULTI drive installed to the server.9. Connect the SATA cable and DC power cable you disconnected in step 4 to the server.This completes the installation procedures.Removal1.12.2You can remove the optical disk drive by reversing the installation procedure.
