8-24 TroubleshootingRECOVERY FOR Windows 2000 SYSTEMIf any file necessary for running the OS is damaged, use the following procedures to recover thesystem.IMPORTANT: After recovering the system, see "Updating the System" in Chapter5 and be sure to update the system.Also on Windows 2000, you need to update all the drivers after thesystem update. For more information, see "Installing and SettingDevice Drivers" in Chapter 5. If the hard disk drive can not be recognized, you can not recover thesystem.Follow the procedure below and use the information in the disk, not system recovery disk, torecover the system.1. Turn on the power of the system.2. Insert Windows 2000 CD-ROM into the DVD-ROM drive of your server.3. Press the RESET switch or press Ctrl, Alt, and Delete to reboot the server. (You mayalso turn off and then on again to reboot the server.)4. If the RAID controller is installed in the system, press F6 in a few seconds when thewindow is in either of the following states.– "Setup is inspecting your computer's hardware configuration ..." is displayed.– A screen with a solid blue background is displayed.IMPORTANT: There is no visible indication on screen when F6 hasbeen pressed.5. When the following message is displayed, press S.Setup could not determine the type of one or more mass storage devicesinstalled in your system, or you have chosen to manually specify an adapter.Currently, Setup will load support for the following mass storage devices.The following message is displayed.Please insert the disk labeledmanufacturer-supplied hardware support diskinto Drive A:*Press ENTER when ready.6. Insert the Windows 2000 OEM-DISK for NEC EXPRESSBUILDER into the floppy diskdrive, and press Enter.A list of mass storage devices is displayed.
