NEC GT1150 User Manual

Also see for GT1150 Series: Supplementary guide Specifications Installation guide Installation data Specifications

Contents

NEC GT1150 User Manual Manual pdf 48 page image

E – 40Menu Descriptions & FunctionsSource SelectWhen Switcher Control is set to "Standalone", you can select a videosource such as a VCR, DVD player, laser disc player, computer, ordocument camera depending on what is connected to your inputs, orPC Card Viewer (PC card installed).Enables you to select a video source such as a VCR, DVD player, laserdisc player, computer or document camera depending on what is con-nected to your inputs.Press the up/down buttons on your remote control or the projector cabi-net to highlight the menu for the item you want to project.* RGB1,2* Video 1,2* S-Video* RGB Digital* RGB Analog* PC Card Viewer* RGB1 (VIDEO)* RGB1 (S-VIDEO)* RGB2 (S-VIDEO)* RGB2 (VIDEO)Entry ListDisplays the list of the entry signals. Use the st buttons on your re-mote control or the projector cabinet to select the signal and press theENTER button on the remote control or the projector cabinet to projectthe image of the selected source.Entry Edit Command (Expert mode only)You can edit the signal on the entry list.To do so:1. While pressing and holding CTL, press ENTER on the remote control todisplay the Entry Edit Command window.* Cut Enables you to remove a selected signal from the list and placeit on the “clipboard” in the projector.* Copy Enables you to copy a selected signal from the list and placeit on the “clipboard” in the projector.* Paste Enables you to paste the signal placed on the “clip-board” toany other line of the list. To do this, select “Paste” and then select theline number you want to paste to. Last press ENTER.* Edit Enables you to change source name or assign the direct key.* The following buttons are not available for the currently projectingsignals:1) The Cut and Paste buttons on the Entry Edit Command screen2) The Input Terminal button on the Entry Edit screenWhen complete, select OK and press ENTER. To exit without storingsetting, select Cancel.SwitcherYou can select the slot number from 1 to 10 of the Switcher(s) ISS-6020.When using with a single Switcher ISS-6020:Use the Select s or t button to select the desired slot number from 1to 10 of the ISS-6020 Swicher and press ENTER.When using with two or more Switcher ISS-6020:Use the Select s or t button to select the master slot number from 1to 10 and then the slave slot number from 1 to 10 on the Select Slotmenu. Select OK and press ENTER.To close the window without storing the settings, select Cancel andpress ENTER.