NEC HT1000 User Manual

Also see for HT1000 Series: Control commands Command guide Command guide Control commands Compatibility chart

Contents

NEC HT1000 User Manual Manual pdf 43 page image

E-43An IP address can be automatically assigned to this projector by yourDHCP server. If your network does not automatically assign IP address,ask your network administrator for an address, and then register it manu-ally.Automatic ....... Automatically assigns an IP address to the projectorfrom a DHCP server.Manual ........... Provides a space for you to register the IP address orsubnet mask number obtained from your network ad-ministrator.IP Address ..... Set your IP address. Press to display the softwarekeyboard and type in 12 numeric characters.Subnet Mask .. Set your subnet mask number. Press to displaythe software keyboard and type in 12 numeric char-acters.Projector Name....................... Specify a unique projector name. Press to displaythe software keyboard and type in. Up to 16 alphanu-meric characters can be used.Gateway ......... Set the default gateway of the network connected tothe projector. Press to display the software key-board and type in 12 numeric characters.Checking this box will make the set default route valid.When data is sent from the LAN card, the transferlocation will be searched according to the previouslyset routing information; however, when the transferlocation has not been found as a result of the search,the data will be sent to the device that holds the IPaddress set here. The IP address that is set here mustbe one that can be identified by a search of the rout-ing information.DNS Configuration....................... Type in the IP address of DNS server on the networkconnected to the projector. 12 numeric characters areused.Domain Name Type in domain name of the network connected tothe projector. Up to 60 alphanumeric characters canbe used.Screen Type:Select either 4:3 Screen or 16:9 Screen for the screen to be used.See also "Aspect Ratio" on pages E-36 and 37.NOTE: When "Resultion" is set to "Native", this selection is inactive.Position:This feature adjusts the vertical position of the image when viewingvideo with an aspect ratio selected.When some aspect ratios are selected in Image Options, the imageis displayed with black borders on the top and bottom.You can adjust the vertical position between top and bottom.NOTE: This option is available only when "16:9" is selected in Screen Type.NOTE: During 3D Reform adjustment, "Screen Type" and "Screen Position"may not be available. To make available, first reset the 3D Reform data andthen do settings again. Secondly repeat the 3D Reform adjustment. Changing"Screen Type" and "Screen Position" can limit 3D Reform in its adjustablerange.Selecting Aspect Ratio and Position for Screen [Screen]Setting LAN ModeThis feature allows you to set various setting items when the projector isused on your network.Consult with your network administrator about these settings.CAUTION: Make sure that the LAN card is removed during Standbymode (NOT Idle mode) or with the main power off.Failure to do so may cause damage to the data on your PC card.Note to Users of a PCMCIA network cardUse of a non-supported network card in the projector may cause theunit to malfunction.Should this happen, turn off the projector and remove the network cardfrom the projector's PC card slot.NOTE: LAN card is not available when a PC card is used for the Viewer function.Viewer is not available when LAN card is used for LAN connection.IP Address