NEC LCD3090WQXI-BK-R User Manual

Also see for LCD3090WQXI-BK - MultiSync - 29.8" LCD Monitor: Specifications Specifications

English-12FINE (Analog input only)Improve focus, clarity and image stability by increasing or decreasing this setting.If the “Auto Adjust function” and the “H.Size” function do not give you a satisfactory picture setting, a fine tuning canbe performed using the “Fine” function.For this a Moiré test pattern could be used. If the Fine value is wrongly calibrated, the result would look like the leftdrawing. The image should be homogeneous.When FINE value iswrong.When FINE value iscorrect.AUTO FINE (Analog input only)This function automatically and periodically adjusts the “FINE” setting for change in signal condition.This function adjusts approximately every 33 minutes.EXPANSIONSets the zoom method.FULL: The image is expanded to 2560 x 1600, regardless of the resolution.ASPECT: The image is expanded without changing the aspect ratio.OFF: The image is not expanded.CUSTOM: Refer to the ADVANCED OSD Controls menu section of the user’s manual for detailed instructions.Color Control SystemsColor Control Systems: Seven preset color settings.For preset settings 1, 2, 3 and 5, the following levels can be adjusted:TEMPERATURE: Adjust the white temperature by increasing or decreasing this setting. A lower color temperaturewill make the screen reddish and a higher color temperature will make the screen bluish.WHITE (White Balance): If TEMPERATURE needs further adjustment, the individual R/ G/ B/ levels of the whitepoint can be adjusted. To adjust the R/G/B levels, CUSTOM must be showing as the TEMPERATURE selection.HUE: Adjusts the hue of each color* 1 . The change in color will appear on screen and the menu color bars will showthe amount of adjustment.SATURATION: Adjusts the color depth of each color* 1 . Press the “RIGHT” button and the color vividness increases.OFFSET: Adjusts the color brightness of each color* 1 . Press “RIGHT” button and the color Brightness increases.*1: RED, YELLOW, GREEN, CYAN, BLUE and MAGENTA.NATIVE, sRGB: Original color presented by the LCD panel that is unadjustable.PROGRAMMABLE: The color tone that was set up with the special application software is reflected.NOTE: To reset a poor image setting, turn on the monitor by using front power button while holding “RESET” and“SELECT” buttons at the same time.ToolsSHARPNESSThis function is digitally capable of keeping independently for crisp image at any time. It is continuously adjustable toget as distinct or as soft an image as you prefer and is set independently for different timings.DVI SELECTIONThis function selects the DVI input mode (DVI-I). When the DVI selection has been changed, the computer has to berestarted.AUTO: When using the DVI-D to DVI-D cable, the DVI SELECTION is DIGITAL.When using the D-SUB to DVI-A cable, the DVI SELECTION is ANALOG.DIGITAL: DVI digital input is available.ANALOG: DVI analog input is available.NOTE: For the MAC with digital output: Before turning on the MAC, the DVI Input mode must be set to DIGITAL in“DVI SELECTION” menu of OSD by pressing “SELECT” button then “CONTROL” button when the DVIsignal cable is connected to the DVI-I connector (DVI-I) of the monitor. Otherwise the MAC may not turn on.NOTE: Depending on the PC and Video card used, or when another Video signal cable is attached, this functionmay not operate.