NEC LT180 User Manual
Also see for LT180 - LT 180 XGA DLP Projector: Supplementary guideControl commandsCommand guideCommand guideControl commands
                                                                         | |
Contents
| 
E-14PC CONTROLCOMPONENT INCOMPUTER INVIDEO INAUDIO INS-VIDEO INRCr/PrCb/PbYLAUDIO INAC INMONITOR OUTCOMPUTER INAUDIO OUTAUDIO INPHONEPHONEAudio cable (not supplied)IBM VGA or Compatibles (Notebook type)or Macintosh (Notebook type)IBM PC or Compatibles (Desktop type)or Macintosh (Desktop type)RGB/VGA signal cable (supplied)To mini D-Sub 15-pin connector on the projector. Itis recommended that you use a commercially avail-able distribution amplifier if connecting a signalcable longer than the one supplied.NOTE: For older Macintosh, use a com-mercially available pin adapter (not sup-plied) to connect to your Mac's video port.Connecting your PC or Macintosh computer to your projector will enable you to project your computer's screenimage for an impressive presentation.To connect to a PC or Macintosh, simply:1. Turn off the power to your projector and computer.2. Use the supplied RGB/VGA signal cable to connect your PC or Macintosh to the projector.3. Turn on the projector and the computer.4. If the projector goes blank after a period of inactivity, it may be caused by a screen saver installed on thecomputer you've connected to the projector.2. INSTALLATION AND CONNECTIONSNOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning on thepower to the notebook PC. In most cases signal cannot be output from RGB output unless the notebook PC is turned on afterconnecting with the projector.* If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or powermanagement software.Making ConnectionsConnecting Your PC or Macintosh Computer |
Related manuals for NEC LT180 - LT 180 XGA DLP Projector
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine