1078. Appendix TroubleshootingThis section helps you resolve problems you may encounter while setting up or using the projector.Indicator MessagesPower IndicatorIndicator Condition Projector Condition NoteOffBlinking lightSteady lightGreenOrangeGreenOrange0.5 sec On,0.5 sec Off2.5 sec On,0.5 sec Off0.5 sec On,0.5 sec OffThe main power is offThe projector is getting ready to turn on.Off Timer is activated.The projector is cooling down.The projector is turned on.The projector is in Standby.–Wait for a moment.–Wait for a moment.––Status IndicatorIndicator Condition Projector Condition NoteOffBlinking lightSteady lightRedGreenOrangeOrangeGreen1 cycle (0.5 sec On,2.5 sec Off)2 cycle (0.5 sec On,0.5 sec Of)3 cycle (0.5 sec On,0.5 sec Off)4 cycle (0.5 sec On,0.5 sec Off)6 cycle (0.5 sec On,0.5 sec Off)1 cycle(0.5 sec On,2.5 sec Off)NormalLamp cover errorTemperature errorPower errorFan errorLamp errorRe-firing the lampNetwork conflictControl Panel Lock is onThe projector is in Standby.–Replace the lamp cover correctly.(→ page 105)The projector is overheated. Movethe projector to a cooler location.Power unit will not work correctly.Fans will not work correctly.Lamp fails to light. Wait a fullminute and then turn on again.The projector is re-firing.Both the built-in LAN and the wirelessLAN cannot be connected to the samenetwork at the same time.To use both built-in LAN and wirelessLAN at the same time, connect them todifferent networks. (→ page 87 )You have pressed cabinet buttonwhen Control Panel Lock is on.(→ page 79)–Lamp IndicatorIndicator Condition Projector Condition NoteOffBlinking lightSteady lightNormalLamp has reached its end of life. Lampreplacement message will be displayed.Lamp has been used beyond its limit. Theprojector will not turn on until the lamp isreplaced.Lamp is in Eco modeRedRedGreen–Replace the lamp.(→ page 104)Replace the lamp.(→ page 104)–
