24OFFVIDEOS-VIDEOVIEWERLANCOMPUTERCOMPONENTONSELECTPOWERPOWERMENUENTEREXIT31 2POWERON/STAND BYPC CARDLAMPSTATUSSOURCEAUTO ADJUST3D REFORM3. Projecting an Image (Basic Operation)This section describes how to turn on the projector and to project a picture onto the screen. Turning on the ProjectorNOTE:• The projector has two power switches: a main power switch and a POWER (ON/STAND BY) button (POWER ON and OFF on theremote control).• When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off ()position. Failure to do so may cause damage to the projector.• The projector has a feature to prevent itself from being used by unauthorized individuals. To use this feature, register a keyword.(→page 42)1. To turn on the main power to the projector, press theMain Power switch to the on position ( I ).• The POWER indicator will light orange.See the Power Indicator section on page 107 for moredetails.2. Remove the lens cap.3. Press the POWER (ON/STAND BY) button on the pro-jector cabinet or POWER ON button on the remotecontrol for a minimum of 2 seconds when the powerindicator turns a steady green, and the projector isready to use.• After you turn on your projector, ensure that the computeror video source is turned on and that your lens cap isremoved.NOTE: When no signal is available, a blue, black or logo screen is displayed.PC CARDCOMPONENT INUSBLANAUDIO INCOMPUTER 3 INCOMPUTER 1 INCOMPUTER 2 INPC CONTROLMONITOR OUTAUDIO OUTS-VIDEO IN VIDEO INAUDIOCb/PbL/MONORYCr/PrAC INPC CARDLAMPSTATUSPOWERON/STAND BYSOURCEAUTO ADJUST3D REFORMSELECTPC CARDLAMPSTATUSPOWERPOWER POWER POWERSTATUSLAMPSTATUSLAMPSTATUSLAMPON/STAND BYStandby Blinking forone minute Power OnSteady orangelightBlinking greenlightSteady greenlight(→ page 107)Press this button for aminimum of 2 seconds.
