NEC MD205MG-1 Installation & Maintenance Manual

Also see for MD205MG-1 - MultiSync - 20.1" LCD Monitor: Specifications Brochure

NEC MD205MG-1 Installation & Maintenance Manual Manual pdf 15 page image

English.5EnglishDisplay Adjustment & MountingRaise and Lower Display ScreenThe display may be raised or lowered in either portrait or landscapemode. To raise or lower the screen, place hands on each side of thedisplay and lift or lower to the desired height.NOTE: Handle with care when raising or lowering the displayscreen and avoid pinching your fingers.Screen RotationBefore rotating, the screen must be raised to the highest level to avoidknocking the screen on the stand or pinching your fingers. To rotate thescreen, place hands on each side of the display screen and turn clockwisefrom landscape to portrait or counterclockwise from portrait to landscape.To rotate the orientation of the OSD menu between landscape and portrait,refer to the “OSD” section, “OSD Rotation” function.Tilt and SwivelGrasp the left and right sides of the display screen with your hands andadjust the tilt and/or swivel as desired.NOTE: Handle with care when tilting the screen.Remove Stand for MountingThis stand can be removed in order to mount the display usingan alternate, VESA approved, mounting method.1. Disconnect all cables.2. Place hands on each side of the display and lift up to thehighest position.Rotate the screen 90° counter clockwise to the landscape position.3. In the landscape position, place the display face down on a nonabrasive surface.Place the screen on at least a 36mm platform so that the stand is parallel with the surface(Figure S.1).4. Remove the 4 screws connecting the display to the stand (Figure S.2).NOTE: Reverse the process to reattach stand.Handle with care when removing monitor stand.Flexible Arm InstallationUse a flexible arm that is strong enough to support the weight of the display (approx 7.3kg).Use the 4 screws that were removed from the stand to attach the flexible arm to the display(Figure S.3).NOTE: Use the original screws (4 pcs) when mounting to avoid damage to the display andstand. To fulfill the safety requirements the display must be mounted to an armwhich guaranties the necessary stability under consideration of the weight of thedisplay. The display can only be used with an approved arm (e.g. GS mark).Figure S.2Figure S.3Figure S.136mm01_MD205MG-1_INSTALL_EN.P65 7/5/08, 10:09 AM5