NEC MultiSync C431 User Manual

Also see for MultiSync C431: User manual User manual Installation guide

Contents

NEC MultiSync C431 User Manual Manual pdf 48 page image

English-46SNMP SettingsClick on “SNMP” on the left column below HOME.The SNMP protocol is used to get status information and to control a monitor directly via the network.Version:SNMP v1 Authenticated plaintext by community name, does not return a confi rmation message of the trap.SNMP v2c Authenticated plaintext by community name, returns a confi rmation message of the trap.Community name:The default setting of community name is “public”. It is read only. You can set community names for up to 3 settings.Trap:Sending error message to a specifi ed address when an error occurs in the monitor.Check Box Explanation Error codeTemperature Temperature abnormal 0xA0, 0xA1, 0xA2Power Power abnormal 0x70, 0x71, 0x72, 0x78Inverter/Backlight Inverter or backlight abnormal 0x90, 0x91No Signal No signal 0xB0System Error System error 0xE0AMX SettingsClick on “AMX” on the left column below HOME.AMX BEACON To turn on or off for the detection from AMX Device Discovery when connecting to a networksupported by an AMX’s NetLinx control system.HINT:When using a device that supports AMX Device Discovery, all AMX NetLinx control systems willrecognize the device and download the appropriate Device Discovery Module from an AMX server.Selecting [ENABLE] AMX Device Discovery will detect the device.Selecting [DISABLE] AMX Device Discovery will not detect the device.CRESTRON SettingsClick on “CRESTRON” on the left column below HOME.CRESTRON ROOMVIEW compatibilityThe monitor supports CRESTRON ROOMVIEW, allowing multiple devices connected in the network to be managed andcontrolled from a computer or a controller.For further information, visit http://www.crestron.comROOMVIEW ROOMVIEW for managing from the computer.ON: Enables ROOMVIEW.OFF: Disables ROOMVIEW.CRESTRONCONTROLCRESTRON CONTROL for managing from the controller.ON: Enables CRESTRON CONTROL.OFF: Disables CRESTRON CONTROL.CONTROLLER IPADDRESSSets the IP address of the CRESTRON SERVER.IP ID Sets your CRESTRON SERVER IP ID.HINT: The CRESTRON settings are required only for use with CRESTRON ROOMVIEW.For further information, visit http://www.crestron.com