NEC MultiSync EA245WMi User Manual

Also see for MultiSync EA245WMi: User manual User manual User manual

English-63. Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position.4. Connect all cables to the appropriate connectors (Figure C.1). When using the USB cable, connect the B type connectorto the USB upstream port on the right back side of the monitor and the A type connector to the downstream port on thecomputer (Figure C.1a). If using the cord from a USB device, plug into the downstream port of the monitor.NOTE: Incorrect cable connections may cause abnormal operation, damage display quality/components of LCD moduleand/or shorten the module’s life.NOTE: Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor turns down the sound.Figure C.1aA TypeB TypeA TypeB TypeB TypeFigure C.1Power cord30° TiltDisplayPortDisplayPort IN/OUT*2DVIDVI HDMIHighestStandPositionAudio InputAudio InputUSB 3.0 UpstreamUSB 3.0 UpstreamControlSync IN/OUT*ControlSync IN/OUT*11USB 3.0 DownstreamD-SUBHeadphoneFigure C.2*1 : See page 10.*2 : See page 11.NOTE: Adjustment of the volume control as well as the equalizer to other settings than the center position may increase theear-/headphones output voltage and therefore the sound pressure level.5. Place the cable holder onto the stand (Figure C.2).Place the cables in the cable holder fi rmly and evenly (Figure C.3 and Figure C.4).6. Please check that you can still rotate, raise and lower the monitor screen after you have installed the cables.Figure C.3 Figure C.4Power CordDVI CableHDMI CableDisplayPort CablesMini D-SUB 15 pin CableControlSync CablesAudio Cable*3Power CordDVI CableHDMI CableDisplayPortCablesMini D-SUB15 pin CableControlSyncCablesAudio Cable* 3*3 : ø 3.5 stereo mini plug.