NEC MultiSync FE1250 FE1250 FE1250 User Manual

NEC MultiSync FE1250 FE1250 FE1250 User Manual Manual pdf 8 page image

6Controls cont.StartColor Control/AccuColor® Control SystemColor presets 1 through 5 selects the desired color setting. The bar is replacedby the color setting choice from 1 to 5. Each color setting is adjusted at thefactory to the stated Kelvin. If a setting is adjusted, the name of the setting willchange from Kelvin to Custom.Red, Green, Blue: NEC’s AccuColor Control System decreases or increases themonitor’s red, green or blue color guns depending upon which is selected. Thechange in color will appear on screen and the direction (decrease or increase)will be shown by the bars.Geometry ControlsGeometry Controls MenuThe Geometry controls allow you to adjust the curvature or angle of the sides ofyour display.Sides In/Out (pincushion): Decreases or increases the curvature of the sides eitherinward or outward.Sides Left/Right (pincushion balance): Decreases or increases the curvature ofthe sides either to the left or right.Sides Tilt (parallelogram): Decreases or increases the tilt of the sides either to theleft or right.Sides Align (trapezoidal): Decreases or increases the bottom of the screen to bethe same as the top.Rotate (raster rotation): Rotates the entire display clockwise or counterclockwise.Tools 1Moiré Canceler: Moiré is a wavy pattern which can sometimes appear on the screen.The pattern is repetitive and superimposed as rippled images. When running certainapplications, the wavy pattern is more evident than in others. To reduce moiré, adjustthe ON/Level by using the –/+ CONTROL buttons.Basic Convergence: Aligns all three colors (R,G,B) to form a single color (white).The purpose of this control is to ensure that a white line drawn on the screen is ascrisp and clear as possible.• Use the Horizontal control to adjust the alignment of the white lines in the up/down direction.• Use the Vertical control to adjust the alignment of the white lines in the left/right direction.Area Convergence: A small window will appear to indicate the area of adjust-ment — Top Horizontal, Top Vertical, Bottom Horizontal or Bottom Vertical.Corner Correction: Allows you to adjust the geometry of the corners of yourdisplay — Top, Top Balance, Bottom or Bottom Balance.78135291.wpc 11/24/99, 8:03 AM8