NEC MultiSync LCD1770V User Manual

Also see for LCD1770NX - MultiSync - 17" LCD Monitor: Specifications Specifications User manual Specifications Brochure & specs

4Display SetupTo attach the MultiSync® LCD monitor to your system, follow these instructions:1. Turn off the power to your computer.2.For the PC or MAC with DVI digital output (NX and NXM only): Connect the DVIsignal cable (not included) to the connector of the display card in your system (Figure1). Tighten all screws.For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to theconnector of the display card in your system (Figure 2). Tighten all screws.For MAC setup: Connect the Macintosh cable adapter to the computer, then attach the15-pin mini D-SUB signal cable to the Macintosh cable adapter (Figure 3). Tighten allscrews.NOTE: To obtain the MultiSync Macintosh cable adapter, call NEC-MitsubishiElectronics Display of America, Inc. at (800) 632-4662.3. Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and liftup to the highest position (Figure 4).4. Connect all cables to the appropriate connectors (Figure 4). NOTE: If connecting bothDVI and D-sub cable, the DVI cable must be connected along side the rib on thepower cord side (Figure 4).5. For successful cable management, place the cables in this order into the cablemanagement: audio cable(NXM only), power cable, and DVI cable (Figure 5).6. Place DVI cable, audio cable(NXM only), and power cable into the specific hooksindicated in Figure 6.7. Place the D-Sub and the USB cable(NX and NXM only) into the specific hooksindicated in Figure 7.8. Make sure all cables are resting flat against the stand (Figure 7).9. Hold the all cables firmly and place the cable cover onto the stand (Figure 8). Toremove the cable cover, lift the cover off as shown in Figure 9.10. Connect the power cord to the power outlet (Figure 10).NOTE: If you use this monitor at AC125-240V, please refer to Recommended Usesection of this manual for proper selection of power cord.11. The vacation switch on the back side of the monitor must be turned on (Figure 10).Turn on the monitor with the front power button and the computer.NOTE: The vacation switch is a true on/off switch. If this switch is on the OFFposition, the monitor cannot be turned on using the front button. DO NOT switchon/off repeatedly.12. Analog input only: No-Touch Auto Adjust automatically adjusts the monitor to optimalsettings upon initial setup for most timings. For further adjustments, use the followingOSM ® controls:• Auto Adjust Contrast • Auto AdjustRefer to the Controls section of this User ’s Manual for a full description of theseOSM controls.NOTE: For download information on the Windows® 95/98/Me/2000/XP INF file foryour monitor, refer to the References section of this User’s Manual.NOTE: If you have any problems, please refer to the Troubleshooting section of thisUser’s Manual.LCD17PISAManual080604.p65 8/6/04, 5:14 PM4