NEC MultiSync LCD4010 User Manual

Also see for MultiSync LCD4010: User guide Specifications Brochure Manual User manual

NEC MultiSync LCD4010 User Manual Manual pdf 11 page image

English-9English1. Determine the installation locationCAUTION: DO NOT ATTEMPT TO INSTALL THE LCDMONITOR BY YOURSELF.Installing your LCD display must be done by a qualifiedtechnician. Contact your dealer for more information.CAUTION: MOVING OR INSTALLING THE LCD MONITORMUST BE DONE BY TWO OR MORE PEOPLE.Failure to follow this caution may result in injury if the LCDmonitor falls.CAUTION: Do not mount or operate the display upsidedown, face up, or face down.CAUTION: This LCD has a temperature sensor and coolingfan. If the LCD becomes too hot, the cooling fanwill turn on automatically. If the LCD becomesoverheated and the cooling fan is running, the“Caution” menu will appear. If the “Caution”menu appears, discontinue use and allow theunit to cool. When the LCD monitor is used in anenclosure or with protection on LCD surface,please check the inside temperature of monitorby “HEAT STATUS” (See page 28). Thetemperature is too hot than normal condition,please set “cooling fan” to ON on SCREENSAVER function (See page 24).IMPORTANT: Lay the protective sheet, which was wrappedaround the LCD monitor when it waspackaged, beneath the LCD monitor so asnot to scratch the panel.2. Install the remote control batteriesThe remote control is powered by 1.5V AA batteries.To install or replace batteries:1. Press and slide to open the cover.2. Align the batteries according to the (+) and (–)indications inside the case.3. Replace the cover.CAUTION: Incorrect use of batteries can result in leaksor bursting.Be careful especially about the following points.• Place “AA” size batteries matching the + and - signs oneach battery to the + and - signs of the batterycompartment.• Don’t mix battery types.• Don’t combine new batteries with used ones.It causes shorter battery life or leakage of batteries.• Remove dead batteries immediately to prevent batteryliquid from leaking into the battery compartment.Don’t touch exposed battery acid, it cause damage toyour skin.NOTE: If you do not intend to use the Remote Control for along period, remove the batteries.3. Connect external equipment(See pages 12-17)• To protect the connected equipment, turn off the mainpower before making connections.• Refer to your equipment user manual.4. Connect the supplied power cord• The power outlet socket should be installed as near tothe equipment as possible, and should be easilyaccessible.• Fully insert the prongs into the power outlet socket.Loose connection may cause noise.• Please fix the power cord by attaching the screw andclamper.NOTE: Please refer to “Safety Precautions, Maintenance &Recommended Use” section of this manual forproper selection of AC power cord.Setup Procedure5. Switch on the power of all attachedexternal equipmentWhen connected with a computer, switch on the power ofthe computer first.6. Operate the attached external equipmentDisplay the signal on the external equipment you wish.7. Adjust the soundMake adjustments when adjustment of the volume isrequired.8. Adjust the screen (See pages 20-28)Make adjustments when adjustment of the screen displayposition or distortion is required.9. Adjust the image (See pages 20-28)Make adjustments when picture adjustment such as thebrightness or contrast is required.Screw ClamperScrew hole for clamper