NEC MultiSync MD213MC Installation And Maintenance Manual

Also see for MD212MC - MultiSync - 21.3" LCD Monitor: Specifications Specification Specifications Specifications Specifications

English-9EnglishMount Flexible arm1. Change the 4 screws that were removed from the stand removal to attach the flexible arm to themonitor (Figure F.1).Caution: • When mounting, use ONLY the screws (4 pcs) that were removed from the stand toavoid damage to the monitor or stand.• The monitor should only be used with an approved arm (e.g. GS mark).• When using mounting accessories (e.g. VESA (100 x 100),use M4 size screws (Length: bracket thickness + 10mm).Recommended Fasten Force: 98 - 137N•cm• To avoid blocking vent, keep adequate space above andbehind the monitor when using with flexible arm.Figure S.2Flexible Arm InstallationThis LCD monitor is designed for use with a flexible arm.To prepare the monitor for alternate mounting purposes:• Refer to instructions included with the flexible arm for detailed instructions.• To fulfill the safety requirements the monitor must be mounted to an arm, which guaranties the necessary stability underconsideration of the weight of the monitor.Remove Monitor Stand1. Remove the cable cover.2. Disconnect all cables.3. Place hands on each side of the monitor and lift up to the highest position.4. Make sure to rotate the screen 90° counter clockwise to the landscape position.5. Place monitor face down on a non-abrasive surface. Be sure to not apply any stress or pressure to the front sensor.To avoid this, lay the display face down on a desk or table with the front sensor situated off the edge (Figure S.1).6. Remove the 4 screws connecting the monitor to the stand (Figure S.2).Reverse process to reattach stand.NOTE: Handle with care when removing monitor stand and avoid pinching yourfingers.Figure S.1Front sensorFigure F.1100 mm100 mmWeight of LCD assembly:7.5 kg (MD212MC/MD213MC)7.7 kg (MD213MG)