NEC MultiSync MD213MC Installation And Maintenance Manual

Also see for MD212MC - MultiSync - 21.3" LCD Monitor: Specifications Specification Specifications Specifications Specifications

English-29EnglishTroubleshootingNo picture• The signal cable should be completely connected to the display card/computer.• The display card should be completely seated in its slot.• Power Switch and computer power switch should be in the ON position.• Check to make sure that a supported mode has been selected on the display card or system being used.(Please consult display card or system manual to change graphics mode.)• Check the monitor and your display card with respect to compatibility and recommended settings.• Check the signal cable connector for bent or pushed-in pins.• Check the signal input, “DVI-D”, “DVI-I” or “D-SUB” (only for MD212MC).Power switch does not respond• Unplug the power cord of the monitor from the AC outlet to turn off and reset the monitor.Image Persistence• Image persistence is when a residual or “ghost” image of a previous image remains visible on the screen. Unlike CRTmonitors, LCD monitors’ image persistence is not permanent, but constant images being displayed for a long period oftime should be avoided. To alleviate image persistence, turn off the monitor for as long as the previous image wasdisplayed. For example, if an image was on the monitor for one hour and a residual image remains, the monitor shouldbe turned off for one hour to erase the image.NOTE: As with all personal display devices, NEC DISPLAY SOLUTIONS recommends using a moving screen saver atregular intervals whenever the screen is idle or turning off the monitor when not in use.Message “OUT OF RANGE” is displayed (screen is either blank or shows rough images only)• Image is displayed only roughly (pixels are missing) and OSD warning “OUT OF RANGE” is displayed: Either signalclock or resolution is too high. Choose one of the supported modes.• OSD warning “OUT OF RANGE” is displayed on a blank screen: Signal frequency is out of range. Choose one of thesupported modes.Image is unstable, unfocused or swimming is apparent• Signal cable should be completely attached to the computer.• Use the OSD Image Adjust controls to focus and adjust display by increasing or decreasing the FINE adjustment.When the display mode is changed, the OSD Image Adjust settings may need to be readjusted.• Check the monitor and your display card with respect to compatibility and recommended signal timings.• If your text is garbled, change the video mode to non-interlaced and use 60Hz refresh rate.LED on monitor is not lit (no green or amber color can be seen)• Power Switch should be in the ON position and power cord should be connected.Display image is not sized properly• Use the OSD Image Adjust controls to increase or decrease the Coarse adjustment.• Check to make sure that a supported mode has been selected on the display card or system being used.(Please consult display card or system manual to change graphics mode.)No Video• If no video is present on the screen, turn the Power switch off and on again.• Make certain the computer is not in a power-saving mode (touch the keyboard or mouse).Self Diagnosis• The LCD display is equipped with the ability to self diagnose abnormalities. When the LCD detects a problem,the LED on the back flashes in a pattern of long and short blinks, depending on the type of problem detected.• If the LED indicates a problem, please refer service to qualified personnel.

/ 32

Related manuals for NEC MD212MC - MultiSync - 21.3" LCD Monitor