NEC MultiSync P212 User Manual

Also see for MultiSync P212: User manual

English-85. To keep the cables neatly organized, place them into the cable management system that is built into the stand.Place the cables in the hooks fi rmly and evenly (Figure C.2 and Figure C.3).6. Please check that you can still rotate, raise and lower the monitor screen when you have installed the cables.Figure C.2 Figure C.3USB CablePower CordDVI Cable D-SUB Cable*1Power CordDVI CableD-SUB Cable*1USB CableDisplayPort CableHDMI Cable*1*1 : Cable not included.7. Slide down the cable cover (Figure D.1).8. Connect one end of the power cord to the AC inlet on the back of the monitor and the other end to the power outlet.NOTE: Please refer to Caution section of this manual for proper selection of AC power cord.9. Turn on the monitor with the front power button (Figure E.1) and the computer.10. No Touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial setup for most timings. For furtheradjustments, use the following OSD controls:• AUTO CONTRAST (Analog input only)• AUTO ADJUST (Analog input only)Refer to the Controls section of this User’s Manual for a full description of these OSD controls.NOTE: If you have any problems, please refer to the Troubleshooting section of this User’s Manual.Figure D.1 Figure E.1Power ButtonRaise and Lower the Monitor ScreenThe monitor may be raised or lowered in either Portrait or Landscape mode.To raise or lower screen, place hands on each side of the monitor and lift or lower to the desired height (Figure RL.1).NOTE: Handle with care when raising or lowering the monitor screen.Figure RL.1