NEC MultiSync P403 User Manual

Also see for P703: Specification Manual Specification Specifications Installation guide

Contents

NEC MultiSync P403 User Manual Manual pdf 23 page image

English-21EnglishPHASEVGA, RGB/HV*1, Y/Pb/Pr, SCART*1 , Y/Pb/Pr2*1inputs onlyAdjusts the visual “noise” on the image. -H RESOLUTIONVGA, RGB/HV*1 inputs onlyAdjusts the horizontal size of the image. -V RESOLUTIONVGA, RGB/HV*1 inputs onlyAdjusts the vertical size of the image. -INPUT RESOLUTIONVGA, RGB/HV*1 inputs onlyIf there is a problem with signal detection, this function forces the monitor to display the signal atthe desired resolution. After selection, execute “AUTO SETUP” if required.If no problem is detected, the only available option will be “AUTO”.AUTOASPECT Select the aspect ratio of the screen image.NOTE: When the ASPECT is DYNAMIC, WIDE or ZOOM, the image will be changed FULLimage before IMAGE FLIP, then start to IMAGE FLIP.When the ASPECT is DYNAMIC or ZOOM, the image will be changed FULL image before TILEMATRIX, then start to TILE MATRIX. After TILE MATRIX, the ASPECT will be returned previousASPECT or set ASPECT during TILE MATRIX.When the ASPECT is DYNAMIC or ZOOM, the image will be changed FULL image before POINTZOOM, then start to POINT ZOOM. After POINT ZOOM, the ASPECT will be returned previousASPECT. When the ASPECT is changed during POINT ZOOM, DYNAMIC and ZOOM will beFULL image.FULLNORMAL Displays the aspect ratio the same as it is sent from the source. -FULL Fills entire screen. -WIDE Expands a 16:9 letter box signal to fi ll entire screen. -DYNAMIC Expands a 4:3 pictures to fi ll the entire screen with non-linearity. Some of the outside image areawill be cut off due to expansion. TILE MATRIX becomes invalid.-1:1 Display the image in a 1 by 1 pixel format. (If the input resolution is higher than a 1920 x 1080resolution, the image will be scaled down to fi t the screen). TILE MATRIX becomes invalid.-ZOOM The image can be expanded beyond the active display area. The image which is outside of activedisplay area is not shown.-ZOOM Maintains the aspect ratio while zooming. -HZOOM Amount of horizontal zoom.VZOOM Amount of vertical zoom.H POS Horizontal position.V POS Vertical position.IMAGE FLIP NOTE: OVER SCAN is disabled when IMAGE FLIP is selected.When the ASPECT is DYNAMIC, WIDE or ZOOM, the image will be changed FULL image beforeIMAGE FLIP, then start to IMAGE FLIP.When selecting IMAGE FLIP except for NONE, following functions are released: PIP MODE,TILE MATRIX, SUPER in INPUT CHANGE, STILL, POINT ZOOM.-IMAGE FLIP Display the inverse image right-left, up-down or rotation.Press + or - to select.NONENONE Normal mode. -H FLIP The image inverts right-left. -V FLIP The image inverts up-down. -180° ROTATE The image rotates 180 degrees. -OSD FLIP Determines the OSD display direction.If “ON” is selected, OSD will invert depending on the image.OFFRESET Resets “ADJUST” settings back to factory settings. -AUDIOVOLUME Increases or decreases output volume level. 40BALANCE Select “STEREO” or “MONO” of audio output.If you select “STEREO”, adjust the balance of L/R volume.Press + button to move the stereo sound image to right.Press - button to move the stereo sound image to left.CENTER,STEREOTREBLE To accentuate or reduce the high frequency sound.Press + button to increase TREBLE sound.Press - button to decrease TREBLE sound.0*1: This function depends on which option board you use.