NEC MultiSync P404 User Manual

Also see for MultiSync P404: Setup guide Installation guide User manual User manual User manual

Contents

English-12Operating Range for the RemoteControlPoints the top of the remote control toward the LCD monitor’sremote sensor during button operation.Uses the remote control within a distance of about 7 m (23 ft.)from remote control sensor or at a horizontal and verticalangle of within 30° within a distance of about 3.5 m (10 ft.).ACTIVE PICTURE buttonSelects active picture.MULTI PICTURE buttonON/OFF button: Toggle switches between ON and OFF.See page 19.MODE button: Selects a mode from PIP (picture in picture)or PBP (picture by picture).CHANGE button: Swaps images between two pictures.PICTURE ASPECT button: Selects active picture frameaspect.NOTE: Enable to change each multi picture size by pressingSET/POINT ZOOM button during multi picture mode.REMOTE ID buttonActivates REMOTE ID function. See page 45.MTS button* 1button* 1Activates closed captioning.NOTE: VIDEO input only.*1: This button’s action depends on which option board you use.Refer to the option board’s user’s manual for further information.NOTE: The buttons with no explanation do not function.Caution: Important, the remote controlsystem may not function whendirect sunlight or strongillumination strikes theremote control sensor orwhen there is an object inthe path.Handling the remote control• Do not subject to strong shock.• Do not allow water or other liquid tosplash the remote control. If the remotecontrol gets wet, wipe it dry immediately.• Avoid exposure to heat and steam.• Other than to install the batteries, do not open the remotecontrol.