NEC MultiSync P404 User Manual

Also see for MultiSync P404: Setup guide Installation guide User manual User manual User manual

Contents

English-19EnglishAspectMP, VIDEOFULL ZOOM NORMALDVI, DisplayPort1, DisplayPort2, VGA (RGB), OPTION*1FULL 1:1 ZOOM NORMALVGA (YPbPr), HDMI1, HDMI2FULL WIDE DYNAMIC 1:1 ZOOM NORMAL*1: This function depends on which option board you use.Aspect ratioof image Unchanged view* 3 Recommended selectionfor picture aspect* 34:3NORMALDYNAMICSqueezeFULLLetterboxWIDE*3 Grey areas indicate unused portions of the screen.NORMAL: Displays the aspect ratio the same as it is sentfrom the source.FULL: Fills entire screen.WIDE: Expands a 16:9 letter box signal to fi ll entire screen.DYNAMIC: Expands a 4:3 pictures to fi ll the entire screenwith non-linearity. Some of the outside image area will be cutoff due to expansion.1:1: Displays the image in a 1 by 1 pixel format.ZOOMThe image can be expanded beyond the active display area.The image which is outside of active display area is notshown.ZOOMZOOMPower IndicatorLED indicatorstatus andlighting patternCondition RecoveryGlowing blue Normal1. Turn on the monitorby remote control orbutton on the backof the monitor.2. Send an AV signalinput to the monitor.Blinking green* 1 Meeting one of the conditionsbelow when the monitor hasbeen past a certain amount oftime with no signal input whichyou set.• The monitor is with an optionboard.• INPUT DETECT is set to asetting except for NONE.• USB POWER is set to ON.• DisplayPort is set to MST.Glowing amber The monitor has been past acertain amount of time with[network signal input] + [noAV signal input which you set].Blinking amber*2 The monitor has been past acertain amount of time with[network signal input] + [noAV signal input which you set].Glowing red Turn off the monitor by remotecontrol or button on the back ofthe monitor.Turn on the monitorby remote control orbutton on the back ofthe monitor.*1: Time setting for AUTO POWER SAVE is available at POWER SAVE(See page 39).*2: Time setting for AUTO STANDBY is available at POWER SAVE(See page 39).NOTE: If the indicator is glowing a combination of longand short in red, a certain failure might haveoccurred. Please contact your nearest authorizedNEC DISPLAY SOLUTIONS service facility.Using Power ManagementThe LCD monitor follows the VESA approved DPM DisplayPower Management function.The power management function is an energy savingfunction that automatically reduces the power consumptionof the display when the keyboard or the mouse has not beenused for a fi xed period.This allows your display to enter a Power management modewhen no signal is applied. This could potentially increase thelife and decrease the power consumption of the display.NOTE: Depending on the computer and display cardused, this function may not operate.