NEC MultiSync P404 User Manual

Also see for MultiSync P404: Setup guide Installation guide User manual User manual User manual

Contents

English-49EnglishConnecting to a NetworkUsing a LAN cable allows you to specify the Network Settings and the Alert Mail Settings by using an HTTP server function.To use a LAN connection, you are required to assign an IP address.Example of LAN connection:ServerHubNOTE: Use a category 5 or higher LAN cable.LAN cable(not supplied)Network Setting by Using an HTTP BrowserOverviewConnecting the monitor to a network allows for monitor control from a computer via the network.To perform the monitor control from a web browser, you must have an exclusive application installed on your computer.The IP address and subnet mask of the monitor can be set on the Network Setting screen of the web browser by using an HTTPserver function. Please be sure to use “Microsoft Internet Explorer 10” or a higher version for the web browser.(This device uses “JavaScript” and “Cookies” and the browser should be set to accept these functions. The setting method willvary depending on the version of browser. Please refer to the help fi les and the other information provided in your software.)Access is gained to the HTTP server function by starting the Web browser on the computer via the network connected to themonitor and entering the following URL.Network Settinghttp:///index.htmlTIP: The default IP address is assigned automatically to the monitor.The exclusive application can be downloaded from our website.NOTE: If the MONITOR NETWORK SETTINGS screen does not appear in the web browser, press the Ctrl+F5 keys torefresh your web browser (or clear the cache).The display or button’s response can be slowed down or operation may not be accepted depending the settings ofyour network. Should this happen, consult your network administrator.The LCD monitor may not respond if its buttons are repeatedly pressed in rapid intervals. Should this happen, wait amoment and repeat. If you still can’t get a response, turn the monitor’s main power off and then back on.To control a monitor please use the control command. See “Control command diagram” (page 49).Controlling the LCD monitor via LAN Control