NEC MultiSync PA231W User Manual

Also see for MultiSync PA231W: Specification User manual Specifications Specifications User manual

English-14FACTORY PRESETSelecting Factory Preset allows you to reset all OSD control settings (BRIGHTNESS, CONTRAST*1, ECOMODE,BLACK, IMAGE CONTROL, COLOR CONTROL SYSTEM, SHARPNESS, PIP MODE, PIP INPUT, PIP LEFT/RIGHT,PIP DOWN/UP, PIP SIZE, USB SELECTION, EDID EXTENSION, OFF TIMER, OFF MODE, OSD LEFT/RIGHT,OSD UP/DOWN, OSD TURN OFF, OSD TRANSPARENCY) back to the factory settings. Individual settings can bereset by highlighting the control to be reset and pressing the RESET button.NOTE: If you want reset to include the Picture calibration settings and SELF COLOR CORRECTION settings,please use Factory Preset in Advanced OSD menu (see page 21).ECO InformationCARBON SAVINGS: Displays the estimated carbon savings information in kg.COST: Displays the electricity cost savings in balance.CARBON CONVERT SETTING: Adjusts the carbon footprint factor in the carbon saving calculation. This initial settingis based on the OECD (2008 Edition).CURRENCY SETTING: Displays electricity pricing in 6 currency units.CURRENCY CONVERT SETTING: Displays electricity savings in kW/hour (US Currency is default).NOTE: This model’s initial setting is “Currency = US$” and its Currency Convert setting = $0.11.This setting can be changed by using the ECO information menu.If you want to use the French setting, please refer to steps below:1. Open menu by pressing the Menu button and select the ECO information menu using the “LEFT” or“RIGHT” key.2. Select Currency setting item pressing the “UP” or “DOWN” key.3. The French currency unit is Euro ( ). You can adjust currency setting to Euro icon ( ) from US dollar ($)using the “LEFT” or “RIGHT” key in Current setting item.4. Select Currency Convert Setting item using the “UP” or “DOWN” key.This initial Euro ( ) setting is Germany of OECD (2007 Edition).Please check receipt of French’s electricity prices or OECD data for French.French of OECD (2007 Edition) was 0.12.5. Adjust Currency Convert Setting item using the “LEFT” or “RIGHT” key.InformationProvides information about the current resolution display (Main picture), current USB input setting and technical dataincluding the preset timing being used and the horizontal and vertical frequencies. Indicates the model and serialnumbers of your monitor.OSD WarningOSD Warning menus disappear with EXIT button.NO SIGNAL: This function gives a warning when there is no Horizontal or Vertical Sync. After power is turned on orwhen there is a change of input signal, the No Signal window will appear.RESOLUTION NOTIFIER: This function warms if resolution other than the optimized resolution is used. After power isturned on or when there is a change of input signal or the video signal doesn’t have proper resolution, the ResolutionNotifier window will open. This function can be disabled in the MENU Tools.OUT OF RANGE: This function gives a recommendation of the optimized resolution and refresh rate. After the poweris turned on or there is a change of input signal or if the video signal doesn’t have proper timing, the Out Of Rangemenu will appear.LUMINANCE WARNING: When the backlight cannot display the desired luminance, a message will appear on thedisplay. To avoid this, reduce the BRIGHTNESS level.INTERLACED SIGNALS ARE NOT SUPPORTED: This function gives a warning when the interlace signal is used.While the image is visible, change the signal of the device from interlaced to progressive (non-interlaced).See “No Picture” in Troubleshooting for detailed information.If you need detailed information about the controls, please use the ADVANCED OSD menu.*1 Only for PA231W/PA241W.