3-10 Setting Up Your ServerTURNING ON THE SERVERTurn on the server and follow the on-screen instructions for setup.IMPORTANT: Before turning on the server: Some optional boards require setups with the BIOS setup utilitybefore installation. If the server has a PCI board with the PCI-to-PCI bridge installed, the BIOS setup utility is enabled to launch.Check on the board specifications to find out whether it requirespre-installation setups before actually installing the board. Some installed optional devices or connected peripheral devicesrequire setups before proceeding to the next step.To use the server with no optional devices installed besides the graphicboard, install a desired OS to the server.1. Make sure all external devices, such as a video display, keyboard, and mouse (optional)have been connected, and the power cords are connected.2. Power on the video display and any other external devices.3. Make sure that the floppy disk drive contains no floppy disk and the CD-ROM drivecontains no bootable CD-ROM.4. Press the POWER/SLEEP switch.NOTES: If the power cord is connected to the power control unit such as theUPS, turn on the power control unit. Connect the power cord and wait a few seconds before pressing thePOWER switch. The POWER/SLEEP switch does not work in afew seconds after connecting the power cord due to firmware start-up.POWER/SLEEP lamp
