8-4 TroubleshootingSTATUS LEDindication Description ActionOn (green) The server is operatingnormally.–The server is operating withthe memory in degradedstate.Identify the device in degraded state by usingthe BIOS setup utility "SETUP," and replace it assoon as possible.Blinking (green)The server is operating withthe CPU error beingdetected.Identify the failed CPU by using the BIOS setuputility "SETUP," and replace it as soon aspossible.Off The server is off-powered. Power on the server.POST is in progress. Wait for a while. The STATUS LED turns greenwhen POST is completed.A CPU error occurred.A CPU thermal error wasdetected.A watchdog timer has timedout.An uncorrectable memoryerror was detected.A PCI system error occurred.A PCI parity error occurred.A PCI bus error occurred.Cycle power to the server. If POST displays anerror message, take a note on the message andcontact your service representative.OffMemory dumping isrequested.Wait until memory dumping completes.A thermal error was detected. Check internal fans for dust or debris. Alsomake sure that the fans are firmly connected.If this error indication persists, contact yourservice representative.On (amber)A voltage error was detected. Contact your service representative.A fan alarm was detected. Make sure that the fan units are firmlyconnected.If this error indication persists, contact yourservice representative.A thermal warning wasdetected.Check internal fans for dust or debris. Alsomake sure that the fan units are firmlyconnected.If this error indication persists, contact yourservice representative.Blinking (amber)A voltage warning wasdetectedContact your service representative.An error was detected oneither of the hard disk drives.Replace the hard disk drive.