Appendix A Boot from Fibre Channel deviceYou can install and start up an operating system on the connected Fibre Channel device from this product.You need to change this product’s BIOS/UEFI settings to this. Follow the instructions below to make correctsettings. If you do not install an operating system on the connected Fibre Channel devicefrom this product, do not change the BIOS/UEFI settings. There are certain combinations of supported OSs and Fibre Channel devices. Donot try installation of other combinations than supported ones. Contact your salesagent for combinations of supported OSs and Fibre Channel devices.PreparationsDo the followings as preparations for the computer where this product is attached and the FibreChannel device where the OS is installed.z Confirm that no built-in disk is connected to the computer which will be started from the FibreChannel device. If a built-in disk is connected, the system may not start or you may encounter othererrors because of device detection sequence.z Select suitable Boot Mode for the OS, if the computer supports changing Boot Mode. If the suitable Boot Mode is unclear, please contact the retailer or service center.z Configure in advance a disk area of LUN 0 on the Fibre Channel device where the OS will beinstalled so that this product can detect it. The LUN (Logical Unit Number) where the OS will be installed should be”0.”z Connect the Fibre Channel connector with the Fibre Channel device’s connector where the OSwill be installed. Connect only the Fibre Channel device where the OS will be installed to preventchanging the BIOS/UEFI settings in a wrong way.Change this product’s BIOS/UEFI settings after above-mentioned preparations.䣐䣱䣶䣫䣥䣧䣐䣱䣶䣫䣥䣧䣐䣱䣶䣫䣥䣧䣐䣱䣶䣫䣥䣧䣐䣱䣶䣫䣥䣧