1255. Using On-Screen MenuSelecting the Signal Format [SIGNAL SELECT(COMP3)]When an output device is connected to the COMPUTER 3 video input connectors, this sets the input signal.RGB/COMPONENT ��������RGB and component signals are identified automatically�VIDEO ���������������������������This switches to the video signal�NOTE: When a video cable (commercially available) is connected to the COMPUTER 3 video input connectors’ G/Y connector, videosignals can be projected. In this case, set to “VIDEO”.[SEAMLESS SWITCHING]When the input connector is switched, the image displayed before switching is held to switch to the new image withouta break due to absence of a signal.[COLOR SYSTEM]This feature allows you to select the TV video signal, which differs from country to country (NTSC, PAL, etc.).This is set to [AUTO] by factory default. Set this if the projector cannot identify the signal automatically.Setting for the Optional Board [SLOT POWER]When using the optional board such as SB-01HC installed in the slot, set the following options.PROJECTOR ON �����������������This feature will turn on or off the power to the optional board.OFF: Forcibly turn off the power to the optional board installed in the slot�ON (Default): Turn on the power to the optional board installed in the slot�PROJECTOR STANDBY �������This feature will automatically enable or disable the optional board installed in the slotwhen the projector is in standby.DISABLE: Select this option to disable the optional board in the projector standby�ENABLE (Default): Select this option to enable the optional board in the projector standby�NOTE:• Select [OFF] when the optional board is not installed into the slot.
