1329. Appendix TroubleshootingIndicator MessagesPower IndicatorLamp IndicatorIndicator Condition Projector Condition NoteOffBlinking lightSteady lightNormalLamp has reached its end of life. Lampreplacement message will be displayed.Lamp has been used beyond its limit.The projector will not turn on until thelamp is replaced.Lamp is in Eco modeRedRedGreenIndicator Condition Projector Condition NoteOffBlinking lightSteady lightGreenOrangeGreenOrange0.5 sec On,0.5 sec Off2.5 sec On,0.5 sec Off0.5 sec On,0.5 sec Off2.5 sec On,0.5 sec OffThe main power is offThe projector is getting ready to turn on.Off Timer (Off Time) is activated.The projector is cooling down.The Program Timer is activated.The projector is turned on.The projector is in Standby.–Wait for a moment.–Wait for a moment.–––Status IndicatorIndicator Condition Projector Condition NoteOff –NormalBlinking lightSteady lightRedGreenOrangeOrangeGreen1 cycle (0.5 sec On,2.5 sec Off)2 cycle (0.5 sec On,0.5 sec Of)4 cycle (0.5 sec On,0.5 sec Off)6 cycle (0.5 sec On,0.5 sec Off)1 cycle (0.5 sec On,2.5 sec Off)Reattach the lamp cover correctly.(m page 126)The projector is overheated. Movethe projector to a cooler location.Fans will not work correctly.Lamp fails to light. Wait a fullminute and then turn on again.The projector is re-firing.Both the built-in wired LAN and thewireless LAN cannot be connected tothe same network at the same time.To use both built-in wired LAN andwireless LAN at the same time, con-nect them to different networks.(m page 108, 109)You have pressed cabinet buttonwhen Control Panel Lock is on.(m page 100)–Lamp cover errorTemperature errorFan errorLamp errorRe-firing the lampNetwork conflictControl Panel Lock is onThe projector is in Standby.Over-Temperature ProtectionO OW–Replace the lamp.(m page 124)Replace the lamp.(m page 124)–THETRUSTEDSOURCEFORPROJECTORLAMPSANDACCESSORIES
