23OFFVIDEOS-VIDEOVIEWERNETWORKCOMPUTERCOMPONENTONSELECTPOWERPOWERMENUENTEREXIT31 2USBLAMPSTATUSPOWERON/STAND BYSOURCEAUTO ADJUST3D REFORM3. Projecting an Image (Basic Operation) Turning on the ProjectorNOTE:• The projector has two power switches: a main power switch and a POWER (ON/STAND BY) button (POWER ON and OFF on theremote control).• When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off (5) po-sition. Failure to do so may cause damage to the projector.• The projector has a feature to prevent itself from being used by unauthorized individuals. To use this feature, register a key-word. (m page 45)1. Remove the lens cap.2. To turn on the main power to the projector, press theMain Power switch to the on position ( I ).WPOWER3. After making sure that the projector is in standbymode, press the POWER (ON/STAND BY) or POWER(ON) button for a minimum of 2 seconds when theSTATUS indicator goes off and the POWER indicatorstarts blinking.When the POWER indicator turns a steady green,and the projector is ready to use.NOTE: When no signal is available, a blue, black or logo screen is displayed.POWER POWER POWERP P POP OmPLAMPSTATUSPOWERON/STAND BYSOURCEAUTO ADJUST3D REFORMSELECTUSBEEROWPWIRELESSWIRELESSUSBLAMPSTATUSPOWEREEROWPTHETRUSTEDSOURCEFORPROJECTORLAMPSANDACCESSORIES
