9. Appendix1449-10. Setting the date and time in the projectorSet the current date and time and daylight saving time in the projector. When set, the date and timeappear in the upper right corner of the MultiPresenter start-up screen.There are 2 ways of displaying the screen for [DATE AND TIME SETTINGS] as shown below.1. Display the on-screen menu and select [SETUP] → [GENERAL] → [DATE AND TIME SETTINGS].(NOTE: At this point, the input terminal switches to [LAN]. )2. Switch the input terminal to [LAN], display the “MultiPresenter start-up screen” and select [TOOLS]→ [DATE AND TIME].Item name DescriptionTIME ZONE SETTINGS Set the time difference between the region where the projector is used and the UTC (UniversalTime, Coordinated).• Initial value: +00:00• When using the projector in Japan, set the time as [+09:00].DATE AND TIME SETTINGS Sets the current date and time.• When shipped from the factory, the time is set to the UTC (Universal Time, Coordinated). Bysetting the time zone of your area, the current date and time will be displayed.• When synchronizing the time with the NTP server on the network to obtain the correct time, set[SYNCHRONIZE TO INTERNET TIME SERVER.] to [ENABLE]. Then enter the IP address of the NTPserver or the [HOST NAME] and perform [UPDATE].SUMMER TIME SETTINGS Set the daylight saving time.• Set the daylight saving time setting to [ENABLE].• Set the start and end of the daylight saving time, as well as each item of the time difference.
