NEC POWERMATE P60D Service Manual

Contents

3-22 OptionsFigure Section 3-18 FD1158C, 1.2-MB Diskette DriveHard Disk DrivesThere are two IDE interface connectors on the system board. One system board IDE con-nector provides a PCI-bus interface. The other system board IDE connector provides thestandard IDE interface. In configurations where the 3 1/2-inch hard disk drive is shippedwith the system unit the PCI-bus IDE connector is used.When installing a second hard disk drive, use the open IDE connector on the cable comingfrom the PCI-bus IDE connector system board IDE connector. The standard IDE connectoron the system board is used when adding a third and fourth IDE hard disk drive. A harddisk controller board is not required. The IDE drives described in this section are thin-height (1-inch x 3 1/2-inch) drives. See the 5 1/4-inch device installation instructions later inthis section.Power ConnectorSignal ConnectorPCB (connectors and jumpers areattached to back of PCB)Terminating ResistorJumperFrontof Drive102Not Used3Drive Address(0, 1, 2, 3)